In this case, tie another registration code or a separate registration code to the secondary unit’s serial number. Since the environment is not standalone with single FortiGate unit but an HA with two units, one has to purchase two (2) VDOM upgrade licenses, one for each unit in the cluster. Secondary (global) $ execute upd-vd-license XXXX-YYYY-ZZZZ-XĮven if user checks the number of VDOM supported again, it will still be the old (10 VDOM). Try to apply the license on the secondary unit, but below happens. Then on the secondary unit check if the number of VDOM supported has reflected on the secondary unit, when checked the number of configurable VDOM, and it’s shows only 10, not 20. Note: Now the primary unit shows '20 VDOMs' are configurable. Primary (global) # execute upd-vd-license XXXX-YYYY-ZZZZ-X Let’s say additional 10 VDOM license were purchased, and got registration code from Fortinet.Īfter obtaining the registration code, generate a license key with that code.Ģ) Go to 'Register/Renew' and enter the above provided registration code.ģ) Select the button 'Register' to complete the registration.Ĥ) Select the product serial number for which this license applies (here provide one of the HA cluster member’s S/N)ĥ) The license key will be generated and displayed on the confirmation page. This may be because user is adding additional client(s) and need to place them in a separate VDOM, however the FortiGate does not support adding additional VDOM because of license limitation (not hardware limitation).įor example, a FortiGate 2000E comes with 10 VDOMs, but can support up to 500 with appropriate license installed One might want to increase the number of configurable VDOMs on the FortiGate in HA. Press 'y' to continue, or press 'n' to cancel.This article describes how to install VDOM license in HA environment.
Once enabled, when an administrator creates a new VDOM, the FortiGate displays a prompt to confirm before the VDOM is created. Starting from version 6.4 onwards, you can also e nable the following to prevent accidentally creating VDOMs in the CLI: Set vdom-mode multi-vdom <- This should be typed in manually. Use the following command for FortiOS v6.2, v6,4: # config system global After that the VDOM will be visible and can be configured. Note: The above command will log out the Admin once. Set vdom-admin enable <- This has to be typed in manually. Use the following command for FortiOS v5.2, v5.4, v5.6, v6.0: # config system global This article explains how to enable a VDOM in the FortiGate.
0 kommentar(er)
